Replying to @intel
@intel Why have you let the old altera.com links rot? FPGAs have long product cycles, and even obsolete parts need support. The first step to re-implementing an old design on new hardware is reproducing the design on the original hardware.
altera.com/products/boards_a…
1
If Intel spent a fraction of the effort they put into rebranding PDFs (don't get me started on changing the binary content of a reference PDF without revision notes) into keeping old documentation, this wouldn't be a problem.
1
A new ebay find arrived this week! GiDEL PROCe-III80-B with a mysterious PSDB_FIBER mezzanine board.
1
3
The PSDB_FIBER mezzanine card has a SFP cage and a camera link connector. There's also a second unpopulated SFP cage footprint.
As far as I can tell, the SFP should connect to a remote SFP-to-camera-link module.
1
1
Every time I use these port definitions, I try to read them aloud without laughing. DIPADIP... DOPADOP... BEEP BOOP
From the Xilinx RAMB36E1 port descriptions:
1
3
Here's a view of the routed board in KiCad. 4 Layers from JLCPCB. I designed the address/data busses to be pin compatible with the MC68020 board I brought up last week.
1
3
While unnecessary, I've challenged myself to route all non-power signals on two layers without vias. "This board is full of through hole parts, I shouldn't need any more holes!"
1
1
I find it is often easier to keep 5V CPLDs handy rather than a library of 7400 series logic. The complex buffering was needed to allow remapping pins to be compatible with both AS6C4008 (RAM) and SST39SF040 (Flash)
1
Despite being out of spec, it seems to work. This is a capture of A[15:0] clocked on TSn (transaction start)
1
1







