zzattack (@zzattack) profile picture
Joined July 2010
Photo by zzattack (@zzattack)Photo by zzattack (@zzattack)Photo by zzattack (@zzattack)Photo by zzattack (@zzattack)
Replying to @audiolympics
Pioline for Tsonga and I'll agree
1
599
Replying to @VeeSTARWilliams
"so surprised she's not #1 in the world" was brutal
1
1,109
Replying to @RazOlsRF
volley?
1
1
276
I've been using a dental xray for pcb inspection. The fov of maybe 25x25mm is quite limiting and larger chips require stitching which is annoying but workable.
2
106
try working with Altium defaults... I never touch it anymore in favor of kicad. Money well wasted.
28
Replying to @obnoxiousMods
looks like 47k resistor
1
1
223
Replying to @XaraVFX
congrat
1
65
I'm guessing from my handwriting it's uH. Measurements could be off, they were done by LCR tweezers and it was quite tedious so definitely not perfect. you can typically deduce the exact component from reference schematics of the surrounding ic
1
1
1
322
any passive component with similar or near primary property will be totally fine
2
1
98
no, ordering instructions are in the github. you can have 5 made for 2 usd
25
Replying to @RetroRandRs
look at the "rev 1.6 128MB ram upgrade". you can stack a new RAM chip on top of any of the other 3 and use only the /CE from its dedicated line
3
117
Replying to @Trineas_ @PurpleRTA
they were nicely modified too, by arcademaster1 iirc
89
thin layer does the trick, apply with cheap brush a.aliexpress.com/_EJaBxWn - alternatively heat with IR first (but always reheat with hot air)
1
121
Replying to @borti4938
can both C8G and I7G speed grades of the fpga be used?
42
Replying to @sthetixofficial
heat up a corner for a few seconds to soften the glue; after that it pulls up easily with fine tweezers and once you have the first part going you can tug on that for a very simple removal
59
Replying to @muzammi70148675
according to my notes it is a 47k resistor, looks like 0201 package
1
1
117
congrats brother. 🤞he grows fast and gets to go home soon! and speedy recovery to his mom. did you pick a name?
1
121